Touring Cup Front Lip Spoiler - Submitted by only1db Tools/Materials Needed: #10 self tapping 3/4inch screws with washers Electric Screwdriver or Drill Hacksaw (or other tool that can put plastic) Jack (preferably not the stock one) Three to Five "C" clamps 1. Turn the wheels all the way to one side. The spoiler is about 9 inches longer then the bumber and it needs to be cut on each side. Center the front of the spoiler. There are three holes in the center and obvioulsy the center hole is the center of the spoiler. 2. Center the front lip spoiler with the center of your front bumper. Clamp the front lip spoiler to the bumper. 3. Clamp the side with the tires facing in and make a mark at the end of the bumper. You will also have to make cuts in the spoiler for the hooks. (What I did however was cut the ends a little shorter then the bumber then made marks for the hooks). Once the hooks are cut out the spoiler will slide back into postion and the spoiler will reach the end of the bumber. 4. Once the marks are made unclamp spoiler and cut the end piece off. Then cut the peice for the hook. Then measure the other side of the bumber with the peice you just cut off and cut the other side. 5. After the side is cut, center the front lip again and clamp it into place. Make marks for the opposite hook. 6. Clamp back into place and check to make sure everything is where it needs to be. 7. Jack car up on one side (or both sides with the use of jack stands) then starting screwing the front lip spoiler directly into the bottom of the bumber. Start with the front and work your way to the side that is jacked up. 8. Repeat step seven for the other side of the bumper, if needed. 9. Lower the car back to the ground. See this thread to discuss this Do It Yourself Guide.

Click here to Return to the Forum · Click here to return to DIY Main Page