MSD DIS2 Install - Submitted by Kaborwildfire First, let's assign each coil a number. The one on the right is Coil #1. The one on the left is Coil #2. 1. Peel away the plastic covering over the wires that is going to each coil. Here is Coil #1: Here is Coil #2: 2. Connecting wires- Here you can see that I spliced the brown/white wire from the MSD unit to the green wire(signal 1) coming from the Coil #1 and the brown/orange wire into the white(+voltage) wire from Coil #1. 3. Connecting wires to Coil #2- Here you can see that I spliced the green/brown wire from the MSD unit to the yellow wire coming from Coil #2 and again the orange/brown wire into the white wire from Coil #2. 4. You should now have 4 wires left coming from the MSD unit and the 4 wires from the coil HARNESS side. Only thing left to do it connect the GREEN wire from the msd unit to the YELLOW wire coming from the COIL HARNESS. Then the WHITE wire from the MSD unit to the GREEN wire coming from the COIL HARNESS. The 2 RED wires from the MSD unit connects to the 2 WHITE wires from the COIL HARNESS. Does not matter which just make sure one goes to each one. Picture of where the limit is located: 5. Supply power to the unit. See this thread to discuss this Do It Yourself Guide.

Click here to Return to the Forum · Click here to return to DIY Main Page