Rear Sway Bar Install - Submitted by clarion 1. Remove the two nuts on the plastic endlinks. 2. Remove the two bolts on each bracket holding the sway bar. Be careful, the sway bar will drop. Carefully remove the sway bar. 3. Install the metal endlinks on the car. Do not tighten them all the way. 4. Place the bushings on the sway bar. Then put the bracket over the bushing. Bolt everything back under the car. Do not tighten all them the way. 5. Connect the endlinks with the sway bar. Put the nut on. Do not tighten all the way. 6. Tighten everything up. This can be done with the car on the ground or in the air. Note: The rear sway bar shown is the 22mm Progress rear sway bar. Installing the 19.2mm Tiburon rear sway bar can be done using the same steps. Click here to discuss this Do It Yourself guide.

Click here to Return to the Forum · Click here to return to DIY Main Page