Two Piece Front Lip Kit Install (On an XD2) - Submitted VTElantra 1. Cut the first couple of inches off the leading edge of the Lip, like this: 2. After those cuts, do a small cut about half way down so it can form better to the bumper. 3. After the center cut either mount the kit and cut the final couple inches off the back nere the tire. You will have to remove the wheel to mount them otherwise they are to long. I trimmed them some before I mounted them and then trimmed the up to perfectly match the bumper. 4. To mount them I just used about five sheet metal screws, and I pre-drilled small wholes so I wouldn't crack the bumper. Finished Product: Click here to discuss this Do It Yourself Guide.

Click here to Return to the Forum · Click here to return to DIY Main Page