greddy timer help

[clarion]

i just got my greddy turbo timer, and im getting readdy to install it, one things is bothering me is the purple wire, it needs to go to the vehicle speed sensor, where would i go and tap a signal from?

[evan938]

there is a speed sensor on the tranny and there is a speed sensor built into the ABS sensor that is behind the pass side front rotor (i found out this was also a speed sensor when i busted it and the OBD2 code was "speed sensor")

[clarion]

isnt there a pin or wire coming out the ecu for it too?

[evan938]

im sure there is. im just saying what im aware of though

[clarion]

ah ha i found it, in the tibby multiguage DIY, it show 3 ways to get the signal from the back of the guages...ill be installing it first thing tommorow
...hopefully

here what it looks like, i got the black oneturbo timer (http://www.prolightstar.com/electronic/greddytimer1.html) i got it cheaper off of ebay

[menallychllngd]

you can hit a tac wire in the main harness somewhere just look at the remote start diy's. southpawboston has a good one written up on gtclub.

[clarion]

thanks, but it looks too confusing, i dont get it? :confused:

[clarion]

ok need more help....i look for the ignition harnes and there are two on the back of the ignition, im trying to use tims turbo timer intall guide but i dont think its for the 01+ elantras, heres a pic of the harness.. the big one there are 4 reds a yellow and white wire. on the small one there are 2 green ones on one pin, a grey one and 2 red ones

all i need to do is hook it up to a 12v, acc., on, and a ground....but i dont know what wires what

[slow 2K2GT]

if that harness is for the ignition than dont wire into that you will only have troubles...check the PM I sent you and hit me back.

[clarion]

i got and 03, those harnesses came strait off the back of the ignition

[slow 2K2GT]

yeah dont use them every wire you should need is on the ECU..ok as I stated in my thread for the install, use the same wires as I did and things should be fine.

[clarion]

ah its all in :) , even hooked up the speed sensor wire and the ebrake wire, thanks you guys so much, everything worked on the first try......now all i need is a turbo :tongue: (sould be coming soon)

[labmixz]

ah its all in :) , even hooked up the speed sensor wire and the ebrake wire, thanks you guys so much, everything worked on the first try......now all i need is a turbo :tongue: (sould be coming soon)

hehe, thats kinda funny that you hooked up the turbo timer before the turbo...

just don't see that everyday ;)

[clarion]

one less thing to install when it comes in, i also ran wires for the light for my boost gauge so thats taken care of too ;) just waiting for tim to come through

i cant get to to play the lil tune its suppost to play when its turned on and off i tried everything........

edit: nevermind mind dont do that :(