PDA

View Full Version : muffler on

FluidGroove
04-23-2006, 02:56 PM
so i got my brothers muffler put on, next up will be springs to lower it. tell me what you all think.

http://i5.photobucket.com/albums/y159/fluidgroove/DSCF0005.jpg
Morgasm69you
04-23-2006, 07:22 PM
cut the bumper to make it look flush with the car...it looks good but it looks like you just stuck it there and said "hmm glue may hold it"
Mad_Hatter
04-23-2006, 07:29 PM
cut the bumper to make it look flush with the car...it looks good but it looks like you just stuck it there and said "hmm glue may hold it"

agreed...
-bill
toymachine566
04-23-2006, 11:09 PM
looks good....i got my exhaust the same way. i havent cut my bumper yet either. is full catback in your future plans?
Vampyrate
04-23-2006, 11:11 PM
im not a big fan of the muffler, but if it sounds nice thats all that matters... i guess that is the main reason why i dont buy a bolt on cat back from ark or shark racing.... i just really dont like that whole look, i would rather perfer a dual tip
KeWLKaT
04-24-2006, 02:29 AM
blah. i wouldnt cut the bumper. once you cut it you are stuck with an aftermarket exhaust if you ever want to switch back or anything
03SilverBullet
04-24-2006, 02:53 AM
If you lower it with that muffler sitting as low as it is you may have problems going out of certain parking lots.
tricked03gls
04-24-2006, 08:55 AM
dont cut it, i did it to mine, and i kick my own *** for doing it, had to find a muffler to tuck in to the cut out part of it
menallychllngd
04-24-2006, 11:56 AM
cut it! you are going to bottom that out so bad. i had mine cut and almost flush with the bumper and i was still bottoming it out.
slvrsleeper
04-24-2006, 05:20 PM
Don't back into any parking spaces with curbs behind or you shall hear the dreaded SCRAPE!!! Especially once you lower it, you won't be able to sneak a roll of dimes under that mother.....
soullesselantra
04-24-2006, 05:25 PM
yeah, mines the same way, but a little bigger, i have 6" of clearance as it is now, when i put my springs on im lookin @ 4"...
FluidGroove
04-27-2006, 10:35 PM
cut the bumper to make it look flush with the car...it looks good but it looks like you just stuck it there and said "hmm glue may hold it"

no we wont be cutting the bumper, were doing everything at lowest possible cost, if it scrapes then it scrapes. also there is an exhaust hanger on there. total cost for muffler+welding was $65.