|
seguin22 10-10-2006, 04:34 PM Ok so I have my o2 sensor located behind my second cat and im getting two codes still from it first code is somthing like high voltage reading and now i just got the second code saying circuit malfunction do you think this is because I have a high flow cat?? Jonny666 10-10-2006, 04:52 PM Nopers, I've had a high flow cat for ages with no CEL. Check your wiring. the stock O2 sensor runs 0-1 volt. Im going to guess you have spliced your signal wire into the power wire for the heater core and the ecu is reciving 12 volts from the battery.....therefore "HIGH VOLTAGE READING" basicly its getting a signal that's way off the charts. i'd just double check all of your connections are correct and you didnt mix them up. seguin22 10-10-2006, 05:50 PM Is the only function of the second o2 sensor to see if the cat is good or not? im just wondering if im losing power with the turbo becuase im getting the cel :confused: Jonny666 10-10-2006, 05:58 PM It also HELPS to monitor if the primary is working properly as well. the main function tho is to monitor the catalytic converter. I have heard that when you have a CEL the ecu goes into "limp mode" but i dont belive this happens unless its a MAJOR problem. It is however something you deffinatly want to get fixed and it shouldnt be too difficult. im willing to bet you've got some of the wires crossed. seguin22 10-13-2006, 04:54 PM Well I checked my wiring and its all right... So Im lost now i wonder if the sensor is going bad, but if it was it wouldnt read anything right??? KeWLKaT 10-13-2006, 05:27 PM might be just bad...? | |