Clutch Spring/Slave Cylinder Modification

[Denki]

Hey this mod is in the elantra xd DIY guide, wot is the purpose of this mod??]

http://www.elantraxd.com/DIY/slave.html

Thanks Grant

[SuperGLS]

Here is the original thread on the old forum.

http://www.elantraxd.com/yabbse/index.php?board=38;action=display;threadid=7549

Run a search over there for more info.

Hope that helps, and welcome to the site.

[Denki]

hey thanks

Grant

[NewtXD]

I have one of the origional production run Elantras-built on 5/14/2000
I tried to remove the restricting valve from the slave cylinder this weekend, but found that I didn't have one at all....check it.

I do have a problem with the resistance of shifts though,
So what I did instead was bore out the inside of the slave cylinder so more fluid moves through it...I went from a 4mm hole to a 6mm hole.

The difference is very noticable too! Clutch still feels right and it is easier to shift especially between 1st and 2nd.

I have pics but refuse to work right on this post so I give up.