PDA

View Full Version : I have questions about my setup tooo!!!


chrisrm82
03-16-2008, 04:54 PM
hey guys, sooo soon as my car gets out of the shop from the wreck ill be installing the unichip with the 5th injector..... i finally know how to hook it all up thanks to kylemorg......so once i have that hooked up i should have a good fuel/air mixture.......but there is still one small problem....no boost controller....so heres my question......can i install a manual boost controller and set a boost cutoff lower than the wastegate spring is set for or do i need to get a spring that is set for lower boost and use the boost controller to raise the boost cutoff.....the previous owner told me the spring is a 12 psi spring......but i want the boost to be able to cutoff around 6 for daily and 10 for racing.....sooo what are my possibilities....any help is very much appreciated thnx

BLK02XD
03-16-2008, 08:06 PM
you'll need a different wastegate spring for lower boost, and use the boost controller to adjust up, are you going lower compression? if so i would probably run 10 daily, that's where i'm at right now.

yamaha
03-16-2008, 08:13 PM
You will need a different spring. You cannot lower boost below that setting.

Cypher
03-16-2008, 08:15 PM
IIRC, clarion had a 7psi spring in the wastegate. let me look

I searched and Tim had told Reggie it was set at 5psi.

chrisrm82
03-16-2008, 10:38 PM
then how come if i floor it juss keeps goin?.....i have to let off at 12 cuz im afraid of blowin it

Cypher
03-16-2008, 10:41 PM
Why would you even let it go that high untuned? Maybe the wastegate is faulty. Is it setup correctly?

bmxdad
03-16-2008, 10:43 PM
Is it hooked up to a boosted feed line?

KeWLKaT
03-17-2008, 01:13 AM
Is it hooked up to a boosted feed line?

What on earth does this sentence mean? I've done it all, and I read your question 10 times and it doesn't make sense.

Silentwolf
03-17-2008, 01:48 AM
I think he's asking if its hooked into the charge piping. (Only logical assumption for measuring boost levels so as to open the waste gate and this being a non-boosted edumicated guess))

bmxdad
03-17-2008, 01:56 AM
I think he's asking if its hooked into the charge piping. (Only logical assumption for measuring boost levels so as to open the waste gate and this being a non-boosted edumicated guess))
Yea ... like he said ^^^

and it made sense when I posted it ... still does kinda.

Is the wastegate getting a signal to open ... hows that.:rolleyes:

chrisrm82
03-17-2008, 02:12 AM
i couldnt tell u at the moment because its in the shop and thats probably the only thing i havent messed with since i bought it was the wastegate.....but im about 95% sure it is from what i remember seeing...

KeWLKaT
03-17-2008, 08:54 AM
Well I would venture to say yes, or else it would have never boosted 5 psi for clarion.