Installing Dino's supervision gauges

[ilanpro]

http://motorroom.com/no3/diy94.jpg
http://img.imotorroom.com/diy/diy94-2.jpg

[BlackElantraGT]

I'm assuming these guages were for the Tiburon? If you notice, on the OEM face, the tach goes up to 8000 rpm. The tach on the Dino guages goes up to only 6000 rpm, but the 6 is all the way at the far end of the tach guage where the 8 normally would have been. Is the tach not accurate then?

[ilanpro]

I'm assuming these guages were for the Tiburon? If you notice, on the OEM face, the tach goes up to 8000 rpm. The tach on the Dino guages goes up to only 6000 rpm, but the 6 is all the way at the far end of the tach guage where the 8 normally would have been. Is the tach not accurate then?
If you notice is a concept to how to do it, is not the xd is a general idea. :rolleyes:

[O_GT]

I'm assuming these guages were for the Tiburon? If you notice, on the OEM face, the tach goes up to 8000 rpm. The tach on the Dino guages goes up to only 6000 rpm, but the 6 is all the way at the far end of the tach guage where the 8 normally would have been. Is the tach not accurate then?
Its off a kia

[04Elantra]

They need to make one for the 04-05 Elantras....I dont even care if its metric!?!?!?

[BlackElantraGT]

I know that this wasn't for the Elantra, but if the Dino guages are supposed to replace whatever guages it's replacing, shouldn't the numbers on the guages match up? One tach goes up to 8000 rpm, and the Dino guages only goes up to 6000 rpm?