Engine mount mod

[slow 2K2GT]

I think was covered somewhere before, Ford can probably enlighten me on this. With the mod he did to the shifter bracket with the "steel putty" to make the rubber bushings hard. Couldnt this be done to the engine mounts as well, just take em' apart and fill back up with this "steel" stuff?

[FordFasteRR]

yes.

you dont want to " take them apart "...

but if you dare to use quick-steel in your motor mounts, you better be ready to suffer if it turns out too hard...

its gonna be almost impossible to remove the quicksteel if you fill up the holes in the stock mount with it...

Good luck ! :)

[slow 2K2GT]

Ok well I may need a few drinks before I try this one than. Thanks Ford