Keyan
06-08-2005, 02:34 PM
Well I installed my mid-pipe to my cat back system just this weekend, (it's a KORE mandrel bent tube)
and this is what I think of it:
For starters, I installed it and drove around a parking lot and it felt severly underpowered. And it sounded stock too. except at idle there is a little move "chug" and when you rev it slightly (keep it under 2500rpm) it putts at you "vrroommm puttputtputt"
AFTER RESETTING THE ECU however...boy, am I glad I put it in! :)
It definatly gives a harder KICK! from standing when you give it a generous amount of gas and at 3k rpms there is definatly a new burst of power there that wasn't there before.
At first I was hesitant to install it because since the header is stock...and i would be leaving the stock muffler on, it would go stock diameter, to KORE diamter, back to stock diameter. But it seems to have worked out.
FORD! Should I dyno it? hahaha
and this is what I think of it:
For starters, I installed it and drove around a parking lot and it felt severly underpowered. And it sounded stock too. except at idle there is a little move "chug" and when you rev it slightly (keep it under 2500rpm) it putts at you "vrroommm puttputtputt"
AFTER RESETTING THE ECU however...boy, am I glad I put it in! :)
It definatly gives a harder KICK! from standing when you give it a generous amount of gas and at 3k rpms there is definatly a new burst of power there that wasn't there before.
At first I was hesitant to install it because since the header is stock...and i would be leaving the stock muffler on, it would go stock diameter, to KORE diamter, back to stock diameter. But it seems to have worked out.
FORD! Should I dyno it? hahaha