Wanted to Say Hi and ask a question

[DJCoolio24]

Just wanted to introduce myself been here about a month now and forgot too. I have a 02 xd and i love it planing on doing a lot to it. I have found this place great , people are really helpful. I did have one question and im not to sure what section to post it in so i might as well ask here while im saying hey. I need to run some wires from under my hood into the inside of my car. I know i have to go through the firewall but i can't find where the wires feed through right now and i don't wanna have to drill through my firewall. Thanks in advance for anyone who can help me with this and its great being a part of this community

[SuperGLS]

Yo, welcome to the site. I think Carbonman had a short DIY on the old EXD (archive). I can't seem to find it, but maybe if you look through the interior or Audio/Video forums over there you'll find it. Good luck.

EDIT- See below. Good looking out rckozma.

[XTRAWLD]

Getting through the firewall can be a real pain.....best of luck when you find the best point of entry - some people have given up and ran wires OUTSIDE the car....not the best IMO but it'll have to do I guess. Welcome to the site.

[rckozma]

Try this DIY. And welcome to the site, ask as many questions as you want, we try to help as best we can. :D

http://www.compactdivisions.com/projects/diy/firewall_diy.html

[OdessitPashka]

welcome!!!

[DJCoolio24]

Thanks for the posts . I gave up on trying to get through the firewall and drilled into the floor of the driver seat just big enough to get wire through then sillaconed it up turned out very nice. I will post pics soon , maybe as an alturnative to going through the firewall cause that was a real sob . I used protective coating around the wire and the overall effect worked great. I thank you all for welcoming me to this great site. Can't wait to get some more money so i can keep adding onto my car :-)

[stefhan]

there is hole inside the driver side fender liner that goes right inside the cab. you have to take off the fender liner and look up to the right , right by the the door jam, its like a 1" or 2" hole , that were i ran all the wires for my neons

[~*Beloved*~]

Welcome welcome! From one noob to another! ^;~

[sed]

already talked to you about it in IM, but the best place IMO is on the passenger side, where the sheet metal starts to stop curving....



remember, that is on the passenger side of the vehicle

shawn :)
http://www.nitrousworld.com/pictures/DSCF0507.JPG