Hyundai Elantra Forum banner

Dashboard Mounted Gauge Install Help

1447 Views 2 Replies 3 Participants Last post by  fishkur
So I just got a 4 in 1 tachometer, oil pressure and temp, and water temp gauge. I was wondering if anyone knew a good way to work the wires in through the engine bay. The only way Id know how to was when I did my neons I routed it through the firewall but that was mounted under the steering wheel so they didn't get in the way. I don't mind drilling I'm all up for fabricating but I just need an attack point. It would be greatly appreciated!:D
1 - 1 of 3 Posts
hey there, the black box on the engine side of the firewall right top dead center behind IM (intake manifold) is your easiest access point for feeding wires/sensor tubes for guages through the firewall. comes out behind center bezel/radio area.

there is a DIY her for it,

there is also a electrical junction block in behind the passenger side door kick plate. I ran lighting electrical via this port as well.

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.